Improvements
1. Added New Templates
1. Added 9 new PETG ESD templates for E2CF, Pro3 and E2:
- Added new material, PETG ESD, and the corresponding templates under E2CF, Pro3 and E2.
- When printing on the E2CF, PETG ESD and PVA+ can be used as support for PETG ESD.
2. Added 3 PET CF templates for E2CF:
- Added new material, PET CF and the corresponding templates under E2CF.
- When printing on the E2CF, PET CF can be used as support for itself.
3. Updated the PA12 CF+ template for E2CF
2. Added new Pro2 Series printers in Hyper Speed Mode
1. Added two Pro2 and Pro2 Plus printers in Hyper Speed Mode.
2. Added 7 materials for Hyper Speed: ABS/PLA, Premium ABS/ASA/PC/PETG/PLA in Hyper Speed Mode for both Pro2 and Pro2 Plus printers, bringing the total to 14 templates.
3. Added new Pro3 Series printing templates in Hyper Speed Mode
1. Added 6 templates for 3 materials, including Premium ASA, PC, and PETG.
Bug Fixes
1. Fixed the issue where when Adaptive Infill is enabled under Advance Settings->Infill, Adaptive Infill can’t take effect after setting the minimum value of Infill Ratio Range to be half or more than the maximum value.
2. Fixed the issue where if Adaptive Support is enabled under Advance Settings->Support, Adaptive Support can’t take effect after setting the minimum value of Infill Ratio Range to be half or more than the maximum value.
3. Fixed the issue where when Belt Raft and Place Seam on Belt Edge are enabled under Advance Settings ->Special, the print start point of the model is not in the middle of the Belt Wall of the Outer Shell and the start point of the support shell is not in the middle of the Belt Wall of the Outer Shell.
4. Fixed the issue where the Belt Wall can’t be accurately judged when enabling Belt Raft.
5. Fixed the issue where the Support Outline and Dense Support Outline were not included in the Belt Wall judgement.
6. Fixed the issue where a moving distance is less than the Belt Wall Minimal Length and the Belt Wall Speed setting is not triggered when some prints start in the middle of the Belt Wall.
7. Fixed the issue where the A-B Boolean operation is performed on model A with texture and model B without texture, resulting in a model without texture. Now, whether or not to add texture to the model after the operation will be judged based on the actual situation, i.e., B-A or A-B.
8. Fixed the issue where the original textured model A performs a retraction and loses its texture after a Boolean operation on model A with texture and model B without texture.
9. Fixed the issue where when exiting the Hyper Speed Mode, the Printer-> Current Type of Printer option is only available for Pro3 and Pro3 Plus.
10. Fixed the issue where a manually added printer is modified in the Remote Connection interface in Hyper Speed Mode, the Printer Type is empty when entering the interface again for editing.
11. Fixed the issue in the Remote Connection interface where the Printer Speed Mode of a Pro3 Series printer modified to Hyper Speed is saved, but after ideaMaker is restarted, the Printer Speed Mode returns to Standard.
